/Shell/Bash/How to boot from grub rescue

How to boot from grub rescue

ls
# This will list all your devices

# Then you have to go through each, type something like this (depends on what is shown by the ls command):
ls (hd0,1)/
ls (hd0,2)/
# ... and so on, until you find:
(hd0,1)/boot/grub OR (hd0,1)/grub
# ... or, in case of "UEFI", it look something like:
(hd0,1)/efi/boot/grub OR (hd0,1)/efi/grub

# Now you have to set the boot parameters accordingly - just type the following (with the correct numbers for your case) and after each line press return:
set prefix=(hd0,1)/grub
# ... or (if grub is in a sub-directory):
set prefix=(hd0,1)/boot/grub

# Then continue with
set root=(hd0,1)
insmod linux
insmod normal
normal

# Now it should boot. Go to the commandline (e.g. start a "terminal") now, and execute:
sudo update-grub
# ... this should correct the missing information and it should boot next time.

# If NOT - you have to go through the steps again an might have to repair or install grub again.

Source: unix.stackexchange.com

Similar codes

4 votes282 views3 answers
Command 'ng' not found, but can be installed with:
Shell/Bash
0 vote301 views1 answer
Install signal desk
Shell/Bash
-1 vote289 views1 answer
E: Unable to locate package mongodb-org
Shell/Bash
0 vote291 views1 answer
Change wsl to version 1
Shell/Bash
1 vote265 views2 answers
Heroku buildpacks
Shell/Bash
95 votes264 views5 answers
Git username password config
Shell/Bash
1 vote286 views4 answers
Elk max virtual memory areas vm.max_map_count [65530] is too low
Shell/Bash
0 vote265 views1 answer
Instalar acrobat reader desde wine en fedora
Shell/Bash
3 votes265 views2 answers
Check permissions for a folder in ubuntu
Shell/Bash
0 vote279 views1 answer
Docker-compose change working dir
Shell/Bash